20100708

MakerBot Note :

I'm searching for a way to decrease the infill density without affecting feed rate or perimeters. I'm told that slowing down the filament flow is not an option since PWM will reduce the torque available to the motor.

Infill width over thickness : affects perimeter as well as infill. good job ... naming that one.
Feed rate : can't turn that up, makes curves render poorly
Flow rate : can't turn that down, motor wont have enough torque

but, there is a
Perimeter Feed rate over Operating Feed rate
Perimeter Flow rate over Operating Flow rate

so.. if I want to change just the infill feed rate, I can speed up the global feed rate then apply a correction here ? Lets try it.

No comments:

Post a Comment